![background image](http://html2.mh-extra.com/html/ibm/n6270/n6270_hardware-and-service-manual_3984027091.webp)
If your system is in...
Then...
A stand-alone configuration
Reboot your system by entering the
following command:
reboot
An active/active configuration
Complete the following substeps:
1.
If the system is in use, enter the
following command from the partner
node; otherwise, go to the next step:
cifs terminate -t
nn
Note:
CIFS automatically restarts when
the node is rebooted during the takeover
and giveback process.
2.
From the partner node's console, enter
the following command:
cf takeover
3.
Give back the target node by entering
the following command:
cf giveback
Note:
if the system is in use, wait for at
least eight minutes to allow host
multipathing software to stabilize before
entering the
cf giveback
command.
Completing the replacement process
Return the failed part to IBM. Contact IBM Service and Support at 1-800-IBM-SERV
(1-800-426-7378) for more information on the return procedure.
Replacing a boot device in an N6200 series system running Data
ONTAP 8.x
The boot device stores a primary and secondary set of system files on it (also
called the
boot image
) that the system uses when it boots. To replace the boot
device, you must complete a specific sequence of tasks.
Before you begin
Before extracting the compressed system files during the boot device installation
process, make sure that the utility you use is set to suppress any automatic CR/LF
conversions in the extracted files.
If you experience any problems during netboot, you can verify the integrity of the
files extracted from the package by comparing the
md5sum
values stored in the
MD5SUMS
file.
About this task
v
You must replace the failed component with a replacement FRU component you
received from your provider.
v
The steps for replacing a boot device in a system running 7-Mode are different
than for a system running Clustered Data ONTAP. You must use the correct
procedure for your version of Data ONTAP.
v
The term
boot device
refers to the USB boot media.
Replacing N6200 series system devices
65
Содержание N6270
