6.
Slide the chassis onto the mounting shelves until the mounting brackets or
front-mounting flanges contact the rack rails. The shelves ensure that the holes
in the mounting brackets and the front-mounting flanges of the chassis align
with the holes in the rack rails.
7.
Move the lift away from the rack.
8.
Install a mounting screw into each of the open mounting holes aligned with the
rack, starting from the bottom.
9.
Visually inspect the alignment of the device. If the device is installed properly in
the rack, all the mounting screws on one side of the rack should be aligned with
the mounting screws on the opposite side and the device should be level.
Install the Device Without a Mechanical Lift
To install the device without a mechanical lift:
■
■
Lift the Chassis into the Rack on page 12
■
Reinstall Components on page 13
Figure 5: Components to Remove from the Front of the Device
10
■
Step 3: Install the Device
IBM Ethernet Appliance J58S Getting Started Guide
