Reinstall Components
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the
IBM Ethernet Appliance J58S Hardware Guide
.
2.
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
3.
Tighten the captive screws or lock any levers for each component installed.
NOTE:
Make sure that all empty slots are covered with blank panels before operating
the device.
Step 4: Connect External Devices and IOC Cables
To connect external devices and IOC cables, perform the following procedures:
■
Connect to a Network for Out-of-Band Management on page 14
■
Connect a Management Console on page 14
■
Connect the IOC Cables on page 14
Figure 8: Connect External Devices and IOC Cables
Step 4: Connect External Devices and IOC Cables
■
13
Step 4: Connect External Devices and IOC Cables
