IBM IntelliStation M Pro 6218, Руководство по диагностике и обслуживанию

Страница: 34 / 168

POST error codes
The following table describes the POST error codes and suggested actions to
correct the detected problems.
Table 3. POST error messages
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing,” on page 65 to determine which components are customer replaceable units
(CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
062 The computer failed to start on three
consecutive attempts.
All caches are disabled. Repeatedly turning
the computer on and off or resetting the
computer might cause this problem.
1. Run the Configuration/Setup Utility program and
make sure that all settings are correct. Use the
Cache Control selection in the Advanced Setup
menu of the Configuration/Setup Utility program to
enable the caches.
2. Reseat the following components:
a. Battery
b. (Trained service technician only)
Microprocessor
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Battery
b. (Trained service technician only)
Microprocessor
c. (Trained service technician only) System board
Note: When the problem is corrected, be sure to
enable the caches.
101, 102, and
106
An error occurred during the system board
and microprocessor test.
(Trained service technician only) Replace the system
board.
151 A real-time clock (RTC) error occurred.
1. Run the diagnostics program.
2. Reseat the battery.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Battery
b. (Trained service technician only) System board
161 The real-time clock battery has failed.
1. Run the Configuration/Setup Utility program, select
Load Default Settings , make sure that the date
and time are correct, and save the settings.
2. Reseat the battery.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Battery
b. (Trained service technician only) System board
18
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide