IBM HH SATA Multi-Burner, Руководство пользователя

Страница: 19 / 36

Chapter 3. Troubleshooting and parts listing
This chapter provides problem-solving information and a parts listing in case you
have to replace the multi-burner drive or signal cable.
Problem solving
The following table lists problems that might occur with the drive.
Table 4. Problems and possible solutions
Problem Solution
You cannot create a multi-session
disc. Make sure that there is enough space on the disc for another session. Writing a
session requires lead-in and lead-out space (approximately 15 MB), in addition
to the data that is recorded.
You cannot write to a DVD or CD.
v
Make sure that the write operation process is not interrupted by a screen
saver program, an antivirus program, an Internet or email program, or other
software. Disable the functions that might interrupt the write operation.
v
Run a defragmentation program on the hard disk drive.
v
Consult the hard disk drive manufacturer or vendor if an older hard disk drive
is conducting a thermal recalibration during a write operation.
v Replace the disc if it is inoperable or scratched.
v Disable the Windows Auto Insert Notify function on the drives.
You cannot eject a DVD or CD. Make sure that the drive is not in the process of writing to the disc, and then try
the following actions:
v Use software to eject the disc.
v Press the eject button to eject the disc.
v Turn off the server. Wait 45 seconds, and then turn on the server and try
using the eject button again.
v
Use the manual-eject button. For more information, see “Manually ejecting a
disc” on page 7.
You cannot read the DVD or CD
after you successfully write to it.
1. The disc might be damaged. Try a new disc or another brand of disc.
2. Avoid writing at the slower 1X speed unless the server requires it.
© Copyright IBM Corp. 2011
9