IBM HC10 - BladeCenter - 7996, Инструкция по установке и эксплуатации

Страница: 25 / 74

If there is no response when you press the KVM select button, you can use the
management-module Web interface to determine whether local control has been
disabled on the blade workstation.
Media-tray select button: Press this button to associate the shared BladeCenter
unit media tray (removable-media drives and front-panel USB ports) with the blade
workstation. The LED on the button flashes while the request is being processed,
and then is lit when the ownership of the media tray has been transferred to the
blade workstation. It can take approximately 20 seconds for the operating system in
the blade workstation to recognize the media tray.
If there is no response when you press the media-tray select button, you can use
the management-module Web interface to determine whether local control has been
disabled on the blade workstation.
The operating system in the blade workstation must provide USB support for the
blade workstation to recognize and use the removable-media drives and USB ports.
The BladeCenter unit uses USB for internal communication with these devices.
Activity LED: When this green LED is lit, it indicates that there is activity on the
hard disk drive, flash drive, or network.
Location LED: The system administrator can remotely light this blue LED to aid in
visually locating the blade workstation. When this LED is lit, the location LED on the
BladeCenter unit is lit also. The location LED can be turned off through the
management-module Web interface or through IBM Director Console.
Information LED: When this amber LED is lit, it indicates that information about a
system error for the blade workstation has been placed in the system-error log. The
information LED can be turned off through the management-module Web interface
or through IBM Director Console.
Blade-error LED: When this amber LED is lit, it indicates that a system error has
occurred in the blade workstation. The blade-error LED turns off only after the error
is corrected.
Power-control button: This button is behind the control panel door. Press this
button to turn on or turn off the blade workstation.
Note: The power-control button has effect only if local power control is enabled for
the blade workstation. Local power control is enabled and disabled through
the management-module Web interface.
Power-on LED: This green LED indicates the power status of the blade workstation
in the following manner:
v Flashing rapidly: The service processor (BMC) on the blade workstation is
handshaking with the management module.
v
Flashing slowly: The blade workstation has power but is not turned on.
v Lit continuously: The blade workstation has power and is turned on.
Sleep-mode LED: When this green LED is lit, it indicates that the blade workstation
is in Sleep mode. The blade workstation can be put in the Sleep or Hibernate mode
by the operating system or by the thin client. The blade workstation can be
awakened through the management-module Web interface, through IBM Director
Console, or by the thin client.
Chapter 2. Power, controls, jumpers, switches, and indicators
13