IBM H3V, Руководство по установке, эксплуатации и обслуживанию

Страница: 61 / 141

Chapter 4. Using Ultrium Media
To ensure that your IBM Ultrium Tape Drive conforms to IBM's specifications for
reliability, use only IBM LTO Ultrium tape cartridges. You may use other
LTO-certified data cartridges, but they may not meet the standards of reliability
that are established by IBM. The IBM LTO Ultrium Data Cartridge can not be used
in other IBM non-LTO Ultrium tape products.
1
LTO cartridge memory a chip that contains information about the cartridge and the tape, as well
as statistical information about the cartridge’s use (For more information,
see “Cartridge Memory Chip (LTO-CM)” on page 4-2.)
2
Cartridge door protects the tape from contamination when the cartridge is out of the
drive
3
Leader Pin The tape is attached to a leader pin, behind the cartridge door. When the
cartridge is inserted into the drive, a threading mechanism pulls the pin
(and tape) out of the cartridge, across the drive head, and onto a
non-removable take-up reel. The head can then read or write data from or
to the tape.
4
Write-protect Switch prevents data from being written to the tape cartridge (For more
information, see “Write-Protect Switch” on page 4-2.)
5
Label area provides a location to place a label (To obtain tape cartridges and bar
code labels, see “Media Supplies” on page C-4.)
6
Insertion guide a large, notched area that prevents the cartridge from being inserted
incorrectly
Figure 4-1. The IBM LTO Ultrium Data Cartridge
© Copyright IBM Corp. 2010
4-1