IBM FlashSystem 710, Руководство пользователя, Страница: 21 / 46

Before you power down the system, unmount the drives from your operating system. Do not turn off the
system by unplugging the power cords.
Powering off the system
You can use the front panel to shut down your storage system.
About this task
To shut down the storage system by using the front panel, complete the following steps:
Procedure
1.
Use the arrow buttons to cycle through the top-level menu and select
Poweroff
, and then press the
Select
button.
2. Press the Select button to confirm the system shutdown.
3.
The front panel display indicates that the system is powering down. When the system is ready, it
automatically shuts off.
Results
To turn the system back on after manual shutdown, press the power button on the system back panel, to
the right of the power supplies.
Restarting the system
You can restart the system manually by using the front panel.
About this task
To restart the system manually by using the front panel, complete the following steps:
Procedure
1. Use the arrow buttons to cycle through the top-level menu to select Restart . Use the Select button to
select this menu item
2. When prompted, use the
↓
button to confirm. The front panel display indicates that the system is
powering off. It automatically shuts off, then in approximately 9-seconds time, the system turns back
on.
Automatic shutdown
The automatic shutdown function can prevent overheating and loss of power.
When the system senses a high system temperature, power out of range, or various other environmental
conditions, the system automatically initiates the shutdown procedure.
Configuring the management controller port using the front panel
display
The storage system supports system monitoring and configuration through the installed Ethernet
management controller port (MCP).
About this task
You must provide the MCP with an IP address, a subnet mask, and a gateway address if used in your
network. There are three possible IP address settings: Static IP, DHCP, or No Ethernet. The default factory
setting is DHCP. For any questions that you have regarding IP assignment values, consult your network
administrator.
IBM FlashSystem 710 User’s Guide
9