IBM Eserver xSeries 455, Часто задаваемые вопросы

Страница: 26 / 46

v See the following table for the xSeries 455 PCI slot numbering assignments.
Configuration Node 1
RXE-100
Side A Node 2
RXE-100
Side B Node 3
RXE-100
Side A Node 4
RXE-100
Side B
One Node 1-6
One Node
RXE-100 Side A
1-6 7-12
One Node
RXE-100 Sides A and B
1-6 7-12 13-18
Two Nodes 1-6 7-12
Two Nodes
RXE-100 Side A
1-6 7-12 13-18
Two Nodes
RXE-100 Sides A and B
1-6 7-12 13-18 19-24
Four Nodes 1-6 7-12 13-18 19-24
Four Nodes
One RXE-100
Sides A and B
1-6 7-12 13-18 19-24 25-30 31-36
Four Nodes
Two RXE-100s
Sides A and B
1-6 7-12 13-18 19-24 25-30 31-36 37-42 43-48
PCI hot-plug features with the Linux operating system
The SuSE Linux Enterprise Server 8 (SLES8) for the Itanium Processor Family
(powered by Unitedlinux 1.0) operating system does not build or load the PCI
hot-plug device driver by default. Use the instructions and information in the
following sections to build and load the device driver and use the PCI hot-plug
features with the SLES8 operating system.
Building the PCI hot-plug device driver
The kernel-source RPM must be installed before you can build the device driver.
Type the following command to determine whether the kernel-source RPM is
installed:
# rpm -q kernel-source
If the kernel source is installed, start at step 2 on page 21. Otherwise, start at step
1.
Complete the following steps to build the device driver;
1. Complete the following steps to install the kernel-source RPM:
a. Insert the Unitedlinux for IPF CD 2 into the DVD/CD-RW drive on the
xSeries 455 server.
b. Type the following command:
# yast2
c. Click Software → Install or remove software .
d. Click Search from the Filter menu and search for kernel-source .
e. Mark the kernel-source package for installation using the check box or the
Actions menu.
f. Click OK or Accept and wait for the installation to be completed.
20
xSeries 455 FAQ: Hints and Tips