IBM eServer xSeries 382 8834, Руководство пользователя

Страница: 21 / 56

Turning off the server
When you turn off the server and leave it connected to ac power, the server can
respond to remote requests to turn on the server. To remove all power from the
server, you must disconnect it from the power source.
Operating systems require an orderly shutdown before you turn off the server. See
your operating-system documentation for information about shutting down the
operating system.
Statement 5
CAUTION:
The power-control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
1
2
Note: After turning off the server, wait at least 5 seconds before you press the
power-control button to turn on the server again.
The server can be turned off in any of the following ways:
v
After the operating system is shut down, or if the operating system stops
functioning, you can press and hold the power-control button for more than 4
seconds to turn off the server.
v
The server can be configured to turn itself off as an automatic response to a
critical system failure.
Chapter 1. Introducing the IBM
Eserver
xSeries 382 Type 8834 server
9