IBM eServer xSeries 225 Type 8647, Руководство по установке

Страница: 45 / 82

Installing a 5.25-inch removable-media drive
Your server comes with one integrated drive electronics (IDE) CD-ROM drive. The
CD-ROM drive bay supports a 5.25-inch, half-high, removable-media drive.
You can install an additional 5.25-inch, half-high, removable-media drive in bay 2.
A three-drop power cable comes with your server. Use this cable to connect power
to the removable-media drives.
Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, be sure to set
the SCSI ID for that device.
Verify that you have all the cables and other equipment specified in the
documentation that comes with the drive.
Complete the following steps to install a removable-media drive in bay 2 (see
“Internal drive bays” on page 18):
1. Review the safety information beginning on page v and “Installation guidelines”
on page 7.
2. Turn off the server and all attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the side cover (see “Removing the side cover” on page 10).
5. Remove the bezel (see “Removing the bezel” on page 11).
6. Remove the support bracket (see “Removing and installing the support
bracket” on page 12).
7. Use a screwdriver to pry the filler panel and EMC shield away from the server.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v
Do not remove the covers. Removing the covers of the laser product could result in
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
v Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the
following. Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.
Chapter 2. Installing options
25