IBM eserver iSeries 270, Руководство по установке

Страница: 8 / 40

__ 7. Remove the empty card assembly
B
by doing the following:
__ a. Unlatch the two latches on the 2884 until the card assembly slightly
“pops” out. Refer to Figure 2
C
.
__ b. Pull on both latches at the same time to remove the card assembly
from the system unit.
__ 8. Locate the 2884 card assembly.
__ 9. Before you remove the blank filler cards and install the memory into the
card assembly
, read the following:
v
Figure 3 on page 5 shows memory card locations on the main storage
card assembly.
v
Fill positions C and D before installing memory cards in positions E , F ,
G , and H .
Figure 2. Location of card assemblies in a 270 or 810 system unit
4
30xx Memory Card Installation V5R2