IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 108 / 573

Step 1322-25
Is the list of all partition(s) you recorded in “Step 1322-11” on page 86 empty?
No Go to “Step 1322-26”.
Yes Go to “Step 1322-33” on page 89.
Step 1322-26
Does the list of all partition(s) you recorded in “Step 1322-11” on page 86 contain
more than one entry?
No Go to “Step 1322-33” on page 89.
Yes Go to “Step 1322-27”.
Step 1322-27
Is the error class recorded in “Step 1322-6” on page 85 AIX?
No Go to “Step 1322-33” on page 89.
Yes Go to “Step 1322-28”.
Step 1322-28
Perform the following steps for each entry in the list of all partition(s) you recorded in
“Step 1322-11” on page 86, except the partition you were using to debug the original
problem.
Step 1322-29
From the HMC VTERM window of a partition in the list of all partitions, type
diag
at the
AIX command prompt.
Step 1322-30
1. When the diagnostic operating instructions are displayed, press Enter.
2. Select the Task Selection option.
Note: If the terminal type is not defined, you are prompted to define it before you
can proceed.
3. Select the Log Repair option.
4. Select the resource associated with the repair action. If the repair action was
reseating a cable or adapter, select the resource associated with that repair action.
If the resource associated with your repair action is not displayed on the Resource
List, select
sysplanar0
.
5. Press commit after you have made your selection.
88 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide