IBM eServer 232 xSeries, Руководство по установке

Страница: 27 / 68

Chapter 2. Installing Options
15
Make sure the fan sink guide fits between the microprocessor and the
microprocessor socket.
9. Press down and latch the spring retention clip on the back of the fan sink (the side
facing the back of the server).
10. Press down and latch the spring retention clip on the front of the fan sink (the side
facing the front of the server).
11. Plug the fan sink into the fan sink connector on the system board (J46). Make
sure the cable is not in a position to interfere with the fan sink operation.
12. If you have other options to install, install them now.
13. Install the cover.
14. Continue with “Cabling the server” on page 19.
Installing a power supply
Install ing or removing a power supply Your server comes with one 385-watt power supply or two 250-watt power supplies.
The 385-watt power-supply configuration can be upgraded with an optional backplane
Fan sink
(Remove thermal tape
liner on installation)
Insure correct alignment
of fan sink, mounting clip,
and mounting socket
Spring retention clip
Fan sink guide