IBM E Server x336 Series, Руководство по установке опций

Страница: 56 / 76

Completing the installation
Complete the following steps to complete the installation:
1. Install the server cover. See “Installing the server cover” on page 44 for more
information.
2. Connect the cables and power cords. See “Connecting the cables” on page 45
for more information.
3. If you have added or removed hardware from the server, update the server
configuration as necessary. See “Updating the server configuration” on page 45
for more information.
Installing the server cover
Complete the following steps to install the server cover:
1. Position the internal cables so that they do not interfere with the cover
installation. See “System-board cable channels” on page 9 for information about
cable routing.
Important: Before sliding the cover forward, make sure that all the tabs on both
the front, rear, and side of the cover engage the chassis correctly. If
all the tabs do not engage the chassis correctly, it will be very
difficult to remove the cover later.
Cover release latch
Fan door
Fan door
2. Position the cover on top of the server and slide it forward.
3. Press down on the cover release latch until the cover properly engages all the
inset tabs on the server.
4. Close the fan doors.
5. Install the server in the rack. See the Rack Installation Instructions that come
with the server for details.
44
IBM xSeries 336 Type 8837: Option Installation Guide