IBM DS3500, Быстрый старт

Страница: 11 / 18

6. Install the left and right bezels on the storage subsystem or expansion enclosure as shown in
Figure 13. Fit the slot on the top of the bezel over the tab on the chassis flange and rotate the bezel
down until it snaps into place. Make sure that the inside surface of the bezel is flush with the chassis.
7. Install the storage subsystem or expansion enclosure components you removed in “Removing the
storage subsystem or expansion enclosure components” on page 5.
Turning on the power - AC models
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
1
2
Important: You must follow the power sequence in the order shown in the following procedure. To
establish power redundancy for enclosures with two power supplies, use at least two power
distribution units (PDUs) in the rack cabinet. Split the power connections from each enclosure
into the separate PDUs. Then, connect the PDUs to external power receptacles that are on
different circuits.
To turn on the storage subsystem ac power, complete the following steps:
1.
Connect a power cord to each power supply in the storage subsystem.
2. Connect the other end of each power cord to the power receptacle.
3.
Turn on the power to the switches, if applicable.
Figure 13. Installing the bezels
11