IBM DS3500, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 180

v
(DS3512 and DS3524) Up to two RAID controllers. Each controller supports the
installation one of the following optional host port adapters:
– 6 Gbps SAS
– 8 Gbps FC
– 1 Gbps iSCSI
v
(EXP3512 and EXP3524) Up to two ESM modules.
v Two power supplies.
Disk drives and bezels
The hot-swap drive bays that are accessible from the front of the DS3512 storage
subsystem and EXP3512 expansion enclosure are shown in Figure 2. The hot-swap
drive bays that are accessible from the front of the DS3524 storage subsystem and
EXP3524 expansion enclosure are shown in Figure 3.
Hot-swap hard disk drive
You can install up to 12 hot-swap SAS or NL SAS hard disk drives in the
DS3512 storage subsystem and EXP3512 expansion enclosure. You can
install up to 24 hot-swap SAS or NL SAS hard disk drives in the DS3524
storage subsystem and EXP3524 expansion enclosure.
Filler panel
The DS3500 storage enclosure and EXP3500 expansion enclosure come
with filler panels in the empty drive bays. Before you install a hard disk
drive, remove the filler panel and save it for future use. Each of the drive
bays must contain either a filler panel or a hard disk drive.
Left-side bezel
The left-side bezel contains the LEDs, as shown in the following illustration.
Hot-swap hard disk drive Filler panel
Bezels
Figure 2. DS3512 storage subsystem and EXP3512 expansion enclosure hot-swap drive
bays and bezels
Figure 3. DS3524 storage subsystem and EXP3524 expansion enclosure hot-swap drive
bays and bezels
Chapter 1. Introduction
7