Ÿ
Select SCSI Device Configuration. The following screen appears.
Ÿ
Verify that the Maximum Sync Transfer Rate is the highest possible and that configurations
settings are enabled (set to yes).
Adaptec AHA-2940 Ultra/Ultra W SCSISelect (TM) Utility v1.23
SCSI Device Configuration
SCSI Device ID
#0
#1
#2
#3
#4
#5
#6
#7
Initiate Sync Negotiation....................
yes
yes
yes
yes
yes
yes
yes
yes
Maximum Sync Transfer Rate...........
40.0
40.0
40.0
40.0
40.0
40.0
40.0
40.0
Enable Disconnection........................
yes
yes
yes
yes
yes
yes
yes
yes
Initiate Wide Negotiation...................
yes
yes
yes
yes
yes
yes
yes
yes
Options Listed Below Have NO EFFECT if the BIOS is Disabled
Send Start Unit Command................
yes
yes
yes
yes
yes
yes
yes
yes
SCSI Device ID
#8
#9
#10
#11
#12
#13
#14
#15
Initiate Sync Negotiation...................
yes
yes
yes
yes
yes
yes
yes
yes
Maximum Sync Transfer Rate..........
40.0
40.0
40.0
40.0
40.0
40.0
40.0
40.0
Enable Disconnection.......................
yes
yes
yes
yes
yes
yes
yes
yes
Initiate Wide Negotiation..................
yes
yes
yes
yes
yes
yes
yes
yes
Options Listed Below Have NO EFFECT if the BIOS is Disabled
Send Start Unit Command...............
yes
yes
yes
yes
yes
ye
yes
yes
Ÿ
Press ESC to return to previous screen.
Ÿ
Select Advanced Configuration Options. The screen below appears.
AHA-2940 Ultra/Ultra W at Bus:Device 00:0Fh
Configuration
Advanced Configuration Options
Plug and Play Scam Support............................................................................................................................................Enabled
Options Listed Below Have NO EFFECT if the BIOS is Disabled
Host Adapter BIOS (Configuration Utility Reserves BIOS Space)..................................................................................Enabled
Support Removable Disks Under BIOS as Fixed Disks..................................................................................................Boot Only
Extended BIOS Translation for DOS Drives > 1 GByte...................................................................................................Enabled
Display <Ctrl-A> Message During BIOS Initialization......................................................................................................Disabled
BIOS Support for Bootable CD-ROM................................................................................................................................Enabled
BIOS Support for Int13 Extensions...................................................................................................................................Enabled
Support for Ultra SCSI Speed...........................................................................................................................................Enabled
Adaptec AHA-2940 Ultra/Ultra W SCSISelect (TM) Utility v1.23
Ÿ
Verify that Extended BIOS Translation for DOS Drives > 1 GByte and BIOS Support for int13
Extensions is enabled.
Ÿ
Press ESC to return to the previous screen.
Ÿ
Exit from Adaptec settings and save any changes.
IBM storage products
Page 14
IBM Hard Disk Drive Technical Support Center version 2.0
34L3743IG10
