IBM Deskstar Deskstar 3, Руководство пользователя

Страница: 174 / 392

4. Press Scroll
↑
or Scroll
↓
until the printer displays
Printer Adjustments
Rear Left Margin Alignment
5. Press Enter to display the current value.
6. Press Scroll
↑
or Scroll
↓
until the desired value for Rear Left Margin Alignment
is displayed.
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8.
Press Start or Return to exit the Menu. See “Exiting the Configuration Menu”
on page 55.
Note: If the left margin alignment is too large for the current print line, an
005
MARGIN ERROR ADJUST MARGIN OR LINE LENGTH
will occur. For more
information on the message, see Chapter 20, “Problem Solving” on page 295.
Rear Paper Load Position
This parameter adjusts the distance of the first printable line to the top of the
paper from −24 to +288 units (2 in.) (where each unit is 0.176 mm [1/144 in.]). The
default value is 0.
To change or check the Rear Paper Load Position:
1. Press Menu.
2.
Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Printer Adjustments
3. Press Enter.
4. Press Scroll
↑
or Scroll
↓
until the printer displays
Printer Adjustments
Rear Paper Load Position
5.
Press Enter to display the current value.
6. Press Scroll
↑
or Scroll
↓
until the desired value for Rear Paper Load Position is
displayed.
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Start or Return to exit the Menu. See “Exiting the Configuration Menu”
on page 55.
ASF Bin 1 Automatic Forms Thickness Adjustment (AFTA)
This parameter allows you to adjust the distance between the paper and the
printhead when the ASF device is installed and the Paper Source parameter is set
to Bin 1. Paper must be loaded for this adjustment to be effective. This adjustment
can be set to one of the following values:
-5 to +3
The printer automatically adjusts the distance between the paper and the
164
4247 Model 003 User’s Guide