IBM DCS3860, Инструкция по установке, использованию и обслуживанию

Страница: 167 / 204

Chapter 9. Specifications for non-IBM rack installation
The following instructions provide safety requirements and rack specifications for
installing the DCS3860 storage system and EXP3800 storage expansion enclosures
into non-IBM racks.
Note: The information in this section applies to 19–inch racks. It is your
responsibility, working with your rack manufacturer, to ensure that the non-IBM
rack chosen meets the safety requirements and specifications listed in this section.
General safety requirements for IBM products installed in a non-IBM
rack or cabinet
The general safety requirements for IBM products installed in non-IBM racks are:
1. Any product or component that plugs into either an IBM power distribution
unit or mains power (via a power cord), or uses any voltage over 42 V AC or
60 V DC (considered to be hazardous voltage) must be Safety Certified by a
Nationally Recognized Test Laboratory (NRTL) for the country in which it will
be installed.
Some of the items that require safety certification may include: the rack or
cabinet (if it contains electrical components integral to the rack or cabinet), fan
trays, power distribution unit, uninterruptible power supplies, multi-outlet
strips, or any other products installed in the rack or cabinet that connect to
hazardous voltage.
Examples of OSHA-approved NRTLs for the U.S.:
v
UL
v
ETL
v CSA (with CSA NRTL or CSA US mark)
Examples of approved NRTLs for Canada:
a. UL (Ulc mark)
b. ETL (ETLc mark)
c.
CSA
The European Union requires a CE mark and a Manufacturer's Declaration of
Conformity (DOC).
Certified products should have the NRTL logos or marks somewhere on the
product or product label. However, proof of certification must be made
available to IBM upon request. Proof consists of such items as copies of the
NRTL license or certificate, a CB Certificate, a Letter of Authorization to apply
the NRTL mark, the first few pages of the NRTL certification report, Listing in
an NRTL publication, or a copy of the UL Yellow Card. Proof should contain
the manufacturer's name, product type and model, standard to which it was
certified, the NRTL name or logo, the NRTL file number or license number,
and a list of any Conditions of Acceptance or Deviations. A Manufacturer's
Declaration is not proof of certification by an NRTL.
2.
The rack or cabinet must meet all electrical and mechanical safety legal
requirements for the country in which it is installed.
The rack or cabinet must be free of exposed hazards (such as voltages over 60
V DC or 42 V AC, energy over 240 VA, sharp edges, mechanical pinch points,
or hot surfaces).
© Copyright IBM Corp. 2013
149