IBM BladeCenter S 7779, Руководство по установке

Страница: 15 / 50

Chapter 4. Removing a power module
You can remove a power module while the BladeCenter S system is powered on.
To remove it, open the release handle and slide the power module out of the
power module bay.
Attention:
v
To maintain proper system cooling, do not operate the BladeCenter S system
without a power module or power module filler in each power module bay.
Install a power module or filler within one minute of the removal of a power
module.
v
If you are removing a functioning power module, make sure that power LEDs
on the remaining power modules are lit and the power management policy you
have chosen supports the removal of the power module. If not, shut down the
operating systems and turn off all of the blade servers, before you proceed. (See
the documentation that comes with the blade server for instructions for shutting
down the blade server operating system and turning off the blade server.)
Power module 3
Power module 4
Release handle
(open)
1. Disconnect the power cable.
2. Open the release handle (rotate the handle down).
3.
Slide the power module out of the power module bay.
4. If you are instructed to return the power module, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
© Copyright IBM Corp. 2007, 2013
9