IBM BladeCenter QS20, Инструкция по установке и эксплуатации

Страница: 54 / 92

C ompletin g the installation
To complete the installation, perform the following tasks, if you have not already
done so.
1 . Install the blade-server be z el assembly on the blade server ( see “ Installing the
blade server be z el assembly ”) .
2. Close the blade server cover ( see “ Closing the blade server cover ” on page 42 ) .
S tatement 21 :
CA U T I ON :
H a z ardous ener g y is present when the blade server is connected to the
power source. A lways replace the blade cover be f ore installin g the blade
server.
3 . Reinstall the blade server into the BladeCenter unit .
4. Turn on the blade server ( see “ Turning on the blade server ” on page 9) .
5 . After you replace the battery or the system-board assembly, reset the system
date and time through the operating system that you installed. For additional
information, see your operating-system documentation.
N ote: If you have j ust connected the power cords of the BladeCenter unit to
electrical outlets, you will have to wait until the power-on L E D on the blade
server flashes slowly before pressing the power-control button on a blade
server.
Installin g the blade server be z el assembly
The following illustration shows how to install the be z el assembly on the blade
server.
Complete the following steps to install the blade-server be z el assembly:
Bezel release buttons
Front bezel
Serial
connector Serial
cable
Control panel
connector
Control panel
cable
Bezel release buttons
Figure 20. Installing the bezel assembly
40
BladeCenter QS20 Type 0200: Installation and User ’ s Guide