IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 97 / 158

Removing a multiplexer expansion module
To remove a multiplexer expansion module or filler, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Make sure the FRR LED on the multiplexer expansion module is lit. This LED
must be lit before removing the module. For more information see “BladeCenter
HT components, controls, and LEDs” on page 14.
3. Pull the release handle or handles to the open position. The module moves out
of the bay approximately 0.6 cm (0.25 inch).
4. Slide the module out of the bay. Within 1 minute, install either another module
or a filler into the module bay.
5. If you are instructed to return the multiplexer expansion module, follow all
packaging instructions and use any packaging materials for shipping that are
supplied to you.
Chapter 4. Removing and replacing BladeCenter HT components
79