IBM BladeCenter Copper Pass-thru, Руководство по установке

Страница: 31 / 56

The following illustration shows how to install a copper pass-thru module in
an I/O module bay in the rear of an IBM
Eserver
BladeCenter T Type 8720 or
8730 or similar BladeCenter unit.
Release
latch
(open)
Release
latch
(open)
Ethernet
switch
module
Copper
pass-thru
module
Filler
module
Filler
module
2
3
L IN
K
O
K LINK OK
1
!
Complete the following steps to install a copper pass-thru module:
1. Make sure that you are using the latest versions of device drivers,
firmware, and BIOS code for your blade server and management module.
Go to the IBM Support Web site, http://www.ibm.com/pc/support/ for
the latest information about upgrading the device drivers, firmware, and
BIOS code for BladeCenter components. The latest instructions are in the
documentation that come with the updates.
2. Review the information in “Safety” on page v, “Installation guidelines” on
page 11, and “Handling static-sensitive devices” on page 11.
Chapter 2. Installing and removing a copper pass-thru module
17