IBM AS/400e, Руководство пользователя

Страница: 56 / 85

Sign on as QSECOFR .
__ 4.
On the AS/400 Main Menu command line, type:
STRSST
Press the Enter key.
__ 5. When the System Service Tool display appears, select the Start a service
tool option. Press the Enter key.
__ 6. When the Start a Service Tool display appears, select the Hardware service
manager option. Press the Enter key.
__ 7. When the Hardware Service Manager display appears, select the Device
Concurrent Maintenance option.
__ 8. Type the Direct Select Address of the position where you are installing the
new disk unit.
__ 9.
Select option 2 (Install device for the action to be performed).
__ 10. Set the time delay for one minute.
01
__ 11. Attention: Disk units are fragile. Handle with care.
Be sure to use the wrist strap provided. Place one end of the wrist strap
around your wrist and connect the opposite end to your system-unit.
__ 12. Find the package that contains the new disk unit assembly and remove it
from the static-protective package. Write the serial number (SN xx-xxxxxxx)
of the disk unit here ______________ before you install it.
__ 13.
Hold the disk unit with the blue handle up.
__ 14. Unlock the blue handle by pulling it out toward you as far as possible
before you install the disk unit into the expansion unit.
__ 15.
Refer to Figure 36 on page 45 and support the bottom of the disk unit
assembly as you slide it half way into the next available position. Do not
push it any further.
Note: Watch the light above the disk unit. When the light comes on and begins to
blink rapidly, you have nine seconds to install the disk unit.
__ 16. On the console, press the Enter key.
__ 17. Refer to Figure 36 on page 45 and when the light starts blinking, slide the
disk unit in and lock it in place by closing the latch.
44
Setting Up Your 5065 or 5066 Expansion Unit V4R5