IBM AnyPlace 4836, Планирование, установка и руководство по обслуживанию

Страница: 56 / 108

Removing the front panel card
1. Remove the back cover as described in “Removing the back cover” on page 28.
2. Remove the system board assembly as described in “Removing the system
board” on page 38.
3. See Figure 27. Disconnect the speaker connections from the card (
E
).
4. Remove the touch cable (
A
) as follows:
a. Locate the gray latches on either side of the cable.
b. Pull backward on the latches to release.
c. Slip the cable out of the slots.
5. Remove the control card cable (
B
) by pulling it out from the card.
6. Unfasten the three screws (
C
) to remove the card.
7. To replace, locate the alignment pin (
D
) and hole and lower the front panel
card onto the pin.
8. Replace the three screws.
Figure 27. Removing the front panel card
40
Anyplace Kiosk 4836