IBM AnyPlace 4836, Планирование, установка и руководство по обслуживанию

Страница: 45 / 108

3. If installed, remove the button cover by prying under one end with a small
screwdriver.
4. Locate and unfasten the five captured screws (see Figure 16) securing the back
cover.
5. Lift the cover to approximately a 60-degree angle (see Figure 16) to release the
hooks and reveal the main planar assembly.
Removing the scanner and scanner window
To remove the scanner, reverse the steps described in “Installing the scanner” on
page 11.
To remove the scanner window:
1. Using a small screwdriver, pry out the scanner window.
2. To replace, place the window in the correct position and snap into place.
Removing the cable covers
Follow these steps to remove and replace the cable covers:
1. Open the covers as described in “Opening the cable covers” on page 9.
2. Remove the hinge pin (see Figure 15 on page 28) and lift to remove the covers.
3. To replace, reverse these steps.
Figure 16. Removing the back covers
Chapter 4. Removing and replacing FRUs
29