IBM 8275, Руководство пользователя

Страница: 26 / 110

2.
Configure the VT100 terminal emulation application as follows:
v
Baud rate: 19200
v
Parity: None
v
Data bits: 8
v
Stop bits: 1
v
Flow control: None
3. Log in to the terminal interface. The terminal interface requires you to log in with
a user name and password. The user name must have Read/Write status. The
default user name is:
admin , and the password is blanks (no password).
4. See “Appendix D. Interface Conventions for the Console” on page 83 for a
description of terminal interface key definitions. You may need to configure your
terminal emulation application to enable use of these keys.
Remotely Attached Terminal
To establish out-of-band connectivity using a remotely attached terminal, make the
physical connections using the following procedure:
1. Unpack the modem and install it according to the manufacturer’s instructions.
2. Attach one of the serial cable (not provided) to the EIA 232 port of the 8275-416
and the other end to your modem as shown in Figure 7.
3. Set up the modem that is attached to the 8275-416 by following these steps:
Figure 6. Out-of-Band Connectivity — Locally Attached Terminal
Figure 7. Out-of-Band Connectivity — Remotely Attached Terminal
12
8275-416 User’s Guide