IBM 8248-L4T, Руководство пользователя

Страница: 82 / 214

Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the disk drive or solid-state drive replacement by using the HSM.”
Completing the disk drive or solid-state drive replacement by using
the HSM
Complete the following task to complete the disk drive or solid-state drive replacement:
1. Return to the console and wait until the Concurrent Maintenance Results display is shown, and then
press Enter.
2. If you return to the Service Action Log display, exit the service action log.
3.
When the HSM display is shown, press
F3
.
Proceed to completing the procedure.
Completing the procedure
Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover. For instructions, see “Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD” on page 147.
2. Verify the installed part:
v
If you replaced the part because of a failure, verify the installed part. For instructions, see
“Verifying a repair” on page 161.
v
If you installed the part for any other reason, verify the installed part. For instructions, see
“Verifying the installed part” on page 149.
3.
To configure the newly installed disk drive or solid-state drive, see “Configuring a disk drive or
solid-state drive in an IBM i system or logical partition” on page 104.
Figure 41. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
66
Disk drives or solid-state drives