IBM 8248-L4T, Руководство пользователя

Страница: 81 / 214

9.
On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the disk drive or solid-state drive replacement by using the HSM” on page 66.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note:
Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
3.
Select the drive that you want to replace and press Enter on the console.
Important: When you press Enter, after your selected time delay, the service indicator light comes on
(solid) for 18 seconds. You then have 18 seconds to slide the drive all the way in and then lock it in
place by pushing in the drive handle. You can set an appropriate time delay of 01 - 19 minutes to
allow adequate time to access the disk drive or solid-state drive.
4. When the solid-state drive identify LED turns on solid, slide the solid-state drive all the way into the
EDR1 PCIe storage enclosure until it is fully seated. Then rotate the handle
(A) to the locked position.
See Figure 41 on page 66.
5. On the console, press Enter to indicate that you have installed the solid-state drive.
6.
Install the bezel
(B)
.
Figure 40. Replacing a disk drive in the system
Replacing a disk drive or solid-state drive
65