IBM 8248-L4T, Руководство пользователя

Страница: 181 / 214

1. On the PCI SCSI Disk Array Manager display, select Recovery
options .
2. If a previous configuration exists on the replacement adapter, this
must be cleared. Select
Clear PCI SCSI Adapter Configuration
and press F3.
3. On the Recovery Options screen, select Resolve PCI SCSI RAID
Adapter Configuration .
4. On the Resolve PCI SCSI RAID Adapter Configuration screen,
select
Accept Configuration on Drives .
5. On the PCI SCSI RAID Adapter selections menu, select the
adapter that you changed.
6.
On the next screen, press Enter.
7.
When you see the Are You Sure selection menu, press Enter to
continue.
8. If you see a
Failed
status message, verify that you selected the
correct adapter, and then repeat this procedure. When the
recovery is complete, exit the operating system.
9. Go to the Closing a service call procedure.
Verifying a repair by using an IBM i system or logical partition
Use this procedure to verify a repair by using the IBM i operating system.
1. Was the system powered off during the repair?
Yes: Continue with the next step.
No: Continue with step 3.
2. Perform the following tasks:
a. Verify that the power cable is plugged into the power outlet.
b.
Verify that power is available at the customer's power outlet.
3. Was the partition powered off during the repair?
Yes: Continue with the next step.
No: Continue with step 6.
4. Select the IPL type and mode for the system or logical partition that the customer uses (see IPL type
mode and speed options in the Service functions).
5. Start an IPL by powering on the system or partition (see Powering on and powering off). Did the
system complete the IPL?
Yes: Continue with the next step.
No: This might be a new problem. Go to the Starting a repair action. This ends the procedure.
6. Did the system or partition remain running throughout the repair, and was the I/O processor, I/O
adapter, or storage device replaced?
Yes: Continue with step 10.
No: Continue with the next step.
7.
Use the service action log or serviceable event view (if the system is managed by an HMC) to look
for any reference codes that are related to this IPL (see Searching the service action log). Are there
any reference codes that are related to this IPL?
Yes: Continue with the next step.
No: If the problem was related to removable media or communications, perform the verification
procedures in the Service functions to verify that the problem is corrected. Then return the
system to the customer and have the customer verify the system date and time.
This ends the
procedure.
Verifying a repair
165