IBM 7944, Инструкция по установке и эксплуатации

Страница: 59 / 150

Tab
Cover
Figure 26. Cover removal
Step 3. If the server has been installed in a rack, slide the server out from the rack enclosure.
Step 4. Press down firmly on the blue tab on the top (near the front of the server) of the cover and slide the
cover toward the rear of the server until the cover has disengaged from the chassis.
Step 5. Lift the server cover off the server and set it aside.
Attention:
For proper cooling and airflow, replace the server cover before you turn on the server.
Removing the DIMM air baffle
Use this information to remove the DIMM air baffle.
To remove the DIMM air baffle, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page iii and “Installation guidelines” on page
41 .
Step 2. Turn off the server and peripheral devices and disconnect all power cords and external cables if
necessary.
Step 3. Grasp the DIMM air baffle and lift the baffle up, making sure that the pin comes out of the pin hole
on the system board to the left of DIMM connector 8.
Chapter 2
.
Installing optional devices
49