IBM 7944, Инструкция по установке и эксплуатации

Страница: 112 / 150

To install the server cover, complete the following steps:
Step 1. Make sure that all cables, adapters, and other components are installed and seated correctly and
that you have not left loose tools or parts inside the server. Also, make sure that all internal cables
are correctly routed.
Important:
Before you slide the cover forward, make sure that all the tabs on both the front, rear,
and side of the cover engage the chassis correctly. If all the tabs do not engage the chassis
correctly, it will be very difficult to remove the cover later.
Step 2. Position the cover on top of the server.
Tab
Cover
Figure 89. Cover installation
Step 3. Slide the cover toward the front of the server.
Step 4. Make sure that the cover correctly engages all the inset tabs on the server.
Step 5. Slide the server all the way into the rack until it latches.
Step 6. Reconnect the external cables and power cords.
Connecting the cables
The following illustrations show the locations of the input and output connectors of the server.
Video
connector USB 1
connector USB 2
connector
Figure 90. Front of server
The following illustration shows the locations of the input and output connectors on the rear of the server.
102
System x3550 M3Installation and User's Guide