IBM 7383, Инструкция по установке и обслуживанию

Страница: 240 / 488

v
Make sure that you have all the cables and other equipment that is specified in
the documentation that comes with the drive.
v
Check the instructions that come with the drive to see whether you have to set
any switches or jumpers on the drive. If you are installing a SAS or SATA
device, be sure to set the SAS or SATA ID for that device.
v
Optional external tape drives and DVD-ROM drives are examples of
removable-media drives. You can install removable-media drives only in bays 1
and 2 on models with eight 3.5-inch, eight, sixteen, twenty-four, and thirty-two
2.5-inch hard disk drives.
v
The electromagnetic interference (EMI) integrity and cooling of the server are
protected by having all bays and PCI slots covered or occupied. When you
install a drive or PCI adapter, save the EMC shield and filler panel from the bay
or the PCI adapter slot cover in the event that you later remove the drive or
adapter.
v
For a complete list of supported options for the server, see http://
www.ibm.com/systems/info/x86servers/serverproven/compat/us.
Removing a 2.5-inch hot-swap hard disk drive
Use this information to remove a 2.5-inch hot-swap hard disk drive.
Before you begin
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the server to halt, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
About this task
To remove a 2.5-inch hot-swap hard disk drive, complete the following steps.
Procedure
1.
Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
2. Open the bezel (see “Opening the bezel media door” on page 37).
3. Press down on the release latch to open the drive handle; then, pull the drive
out of the drive bay.
222
System x3500 M4 Type 7383: Installation and Service Guide