IBM 7199-92X, Инструкция по установке и эксплуатации

Страница: 47 / 82

The rear of the appliance has the following LEDs:
A, B and C
The fan module LEDs indicate the following status:
v
If the amber LED is lit, there is a problem with the fan module.
v If the amber LED is not lit, the fans are operating normally.
D and E
The power supply module LEDs indicate the following status:
v
If the amber power LED is lit, the power supply has an error.
v
If the LED is not lit, the power supply is working as expected.
Viewing status providers for sensors
The DataPower appliance provides the following sensors status providers:
Fan speed sensors
Provides the measured speed in revolutions per minute (RPM) for each of
the fans in each fan module.
From the command line, enter status fan .
Temperature sensors
Provides the measured temperature for internal components:
v
Temperature of each of the two internal CPU components
v
Temperature of each of the two internal inlet air temperatures
v
Temperature of each of the two outlet air temperatures
v
System ambient temperature
From the user interface, click Appliance
→
Troubleshooting
→
Hardware
Temperatures .
From the command line, enter status temperature .
Voltage sensors
Provides the measured voltage for the internal components.
From the command line, enter status voltage .
RAID battery backup status
Monitors the battery backup unit on the RAID controller.
From the command line, enter status raidphystatus .
A
C B D E
Figure 13. LEDs on the rear on the Type 7199 appliance
Chapter 5. Diagnosing your appliance
29