IBM 7163, Руководство по диагностике и обслуживанию

Страница: 79 / 210

5. Press each pair of prongs together to release the guide from the I/O board.
6. If you are instructed to return the Remote Supervisor Adapter II SlimLine guide,
follow all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
Replacing the Remote Supervisor Adapter II SlimLine guide
To install the replacement Remote Supervisor Adapter II SlimLine guide, complete
the following steps:
1. Align the Remote Supervisor Adapter II SlimLine guide on the chassis and press
the guide into place.
2. Install the Remote Supervisor Adapter II SlimLine (see “Replacing the Remote
Supervisor Adapter II SlimLine” on page 58).
3. Install the top cover (see “Replacing the top cover” on page 42).
4. Connect the cables and power cords (see “Connecting the cables” on page 40
for cabling instructions).
5. Turn on all attached devices and the server.
Removing a microprocessor/memory card air baffle
To remove a microprocessor/memory card air baffle, complete the following steps.
Air baffle
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Removing the top cover” on page 41).
4. Remove the microprocessor/memory card (see “Removing a
microprocessor/memory card” on page 51).
5. Place the microprocessor/memory card on a flat surface with the DIMM
connectors facing up.
6. Lift open the microprocessor/memory card air baffle.
Chapter 4. Removing and replacing server components
63