IBM 7163, Руководство по диагностике и обслуживанию

Страница: 78 / 210

10. Lift the media backplane out of the server.
11. If you are instructed to return the CD/DVD media backplane, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing the CD/DVD media backplane
To install the replacement CD/DVD media backplane, complete the following steps:
1. Align the CD/DVD media backplane at the rear of the CD/DVD bay.
2. Install the two screws that secure the backplane.
3. Connect the DVD drive signal and DVD drive power cables.
4. Connect the operator information panel ribbon cable and secure the ribbon
cable to the chassis, using the hook-and-loop fastener.
5. Slide the DVD drive into the drive bay until the drive engages.
6. Install the top-cover latch bracket (see “Replacing the top-cover latch bracket”
on page 57).
7. Install the top cover (see “Replacing the top cover” on page 42).
8. Connect the cables and power cords (see “Connecting the cables” on page 40
for cabling instructions).
9. Turn on all attached devices and the server.
Removing the Remote Supervisor Adapter II SlimLine guide
To remove the Remote Supervisor Adapter II SlimLine guide, complete the following
steps.
Remote Supervisor
Adapter II
SlimLine connector
Remote Supervisor Adapter II
SlimLine guide
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Removing the top cover” on page 41).
4. Remove the Remote Supervisor Adapter II SlimLine (see “Removing the
Remote Supervisor Adapter II SlimLine” on page 58).
62
IBM System x3755 Type 8877 and 7163: Problem Determination and Service Guide