IBM 6400-i05, Руководство по установке

Страница: 277 / 370

Fault Correction Procedure
277
009 INVALID KEY PRESS Yes Appears briefly if an
inactive key is pressed in
current print mode. Re–enter the value, or
press the correct key.
010 PARAMETER ERROR No Illegal parameter value
received in command
code. Contact your system
administrator.
011 SCS COMMAND
ERROR No Printer received
undefined control
character. Contact your system
administrator.
012 STRUCTURED FIELD
ERROR No Applications software
has violated structured
data field parameters. Contact your system
administrator.
013 ACTIVATE LOST No Printer detects twinax
protocol communication
errors. The printer reports the
error.
014 INVALID ACTIVATE No Printer detects twinax
protocol communication
errors. The printer reports the
error.
015 COMMUNICATION
CHECK
CHECK CABLE
Yes Line not active. (Twinax
interface) Check cable connection.
016 INVALID COMMAND No Printer detects twinax
protocol communication
errors. The printer reports the
error; host action is
required.
017 STACKER JAM
CHECK STACKER
Yes Paper is jammed in the
power stacker area. Remove paper.
018 STACKER FULL
CHECK STACKER
Yes Power stacker is full of
paper. Remove paper.
019 STACKER FAULT
CHECK STACKER
Yes Stacker is not functioning
correctly Check for obstructions in
the stacker area. If fault
persists, contact your IBM
service representative.
021 RECEIVE BUFFER
OVERRUN
VERIFY CONFIGURATION
Yes Receive overrun. (Serial
interface) Check printer serial port
configuration setup.
Ensure that baud rate
matches both host and
printer settings.
Table 12: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution