IBM 6400-i05, Руководство по установке

Страница: 201 / 370

ANSI
201
Character Set
This parameter selects a character set for the ANSI emulation. Note that
when 0876 OCR-A or 0877 OCR-B is selected as the print language, the Font
Attributes Typeface parameter is changed to OCR-A or OCR-B, respectively.
Character sets are shown in detail in the Character Sets Reference Manual.
Printer Select
•
ON = DC1/OFF = DC3 (the default). Disables the printer when a DC1
control code is received, and enables the printer when a DC3 control
code is received.
•
Disable. Ignores the DC1 and DC3 control codes.
ESC c Sequence
•
Enable (the default). An ESC c code received from the host resets the
printer parameters to the factory defaults.
•
Disable. An ESC c code received from the host is ignored.
Reset Command
When the printer receives a host data stream reset command
(ESC @ or ESC[K) in addition to resetting printer variables, the selected
configuration will be loaded.
•
Disable (the default). The active emulation parameters are loaded when
the reset command is executed.
•
Power-Up Config. The power-up configuration is loaded when the reset
command is executed.
•
Current Config. The currently selected configuration is loaded when the
reset command is executed.
•
Factory Config. The factory installed configuration is loaded when the
reset command is executed.
Received CR
•
Observe (the default). A CR code received from the host is handled as a
carriage return.
•
Ignore. A CR code received from the host is ignored.
Received DEL
•
Observe (the default). A DEL code received from the host is handled as a
Delete command.
•
Ignore. A DEL code received from the host is ignored.