IBM 621410U - IntelliStation E - Pro 6214, Руководство по техническому обслуживанию аппаратной части

Страница: 44 / 176

turn on the computer. Select Stay Off if you want the computer to remain off after
power is restored. Select Last State to have the computer return to its previous
state.
Low Power Entry and Exit Activity Monitor: Select this choice to set up the
system activities that will be monitored for automatic power management.
Automatic Power On: Select this choice to control Automatic Power On when
your computer is unattended. You can set the Wake on LAN feature, Serial Port A
Ring Detect, PCI Modem Ring Detect, Wake Up on Alarm, and PCI Wakeup.
Exit
When you finish viewing or changing settings, select Exit from the menu bar at the
top of the IBM Setup Utility screen, then select Save and exit the Setup Utility
and press Enter. If you do not want to save your changes, select Exit the Setup
Utility without saving and press Enter.
If you want to save a change, but you do not want to leave the IBM Setup Utility
program, select
Save Settings and press Enter.
You can select Restore Settings to load previous values for all Setup items, or your
can
Load Default Settings for the computer.
Using the SCSISelect Utility program (some models)
SCSISelect is a built-in, menu-driven configuration utility program that you can
use for models that come with a SCSI adapter to:
v
View the default SCSI IDs
v
Locate and correct configuration conflicts
v
Perform a low-level format on a SCSI hard disk
The following sections provide the instructions needed to start the SCSISelect
Utility program and descriptions of the menu choices available.
Starting the SCSISelect Utility program
To start the SCSISelect utility program:
1.
Turn on the computer.
2. When the
<<< Press <CTRL><A> for SCSISelect
™
Utility! >>>
prompt
appears, press Ctrl+A.
Note: If an administrator password has been set, a prompt appears asking you
to type the password to start the SCSISelect Utility program.
3. When the
Would you like to configure the host adapter or run the SCSI
disk utility?
question appears, make your selection and press Enter.
4. Use the arrow keys to select a choice from the menu.
v
Press Esc to return to the previous menu.
v
Press the F5 key to switch between color and monochrome modes (if your
monitor permits).
5. Follow the instructions on the screen to change the settings of the selected
items, and press Enter.
36
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214