IBM 4810-E3H, Инструкция по установке и обслуживанию

Страница: 29 / 88

Removing and installing the hard disk drive and hard disk tray as an
assembly
To remove the hard drive and tray as an assembly:
v Open the unit. See “Removing and installing the top cover” on page 12.
v Grasp the tray assembly
1
where the arrows originate
2
.
v Pull the tray assembly in an upward direction as shown by the arrows; this will
disengage the tray assembly retainers.
To install the hard drive and tray as an assembly:
1. Align the hard drive tray with the three alignment features
3
. Move the hard
drive tray down and over the alignment features
3
and snap into place.
2. Ensure that the hard drive is completely seated on the alignment pins and the
front of the tray is correctly positioned in the slots on the chassis.
3. Replace the cover. See “Removing and installing the top cover” on page 12.
2
3
2
1
3
3
Figure 8. Removing the hard drive and hard drive tray as an assembly
March 2009
Chapter 3. Removal and installation procedures for the 4810/4910 SurePOS 300
15