IBM 4685-L0D, Руководство по установке, эксплуатации и обслуживанию

Страница: 40 / 80

Sleep mode control
To maximize the lifetime of the laser and the motor, the 4685-L0D scanner goes
into sleep mode after the scanner is left inactive for a specified period of time. You
can specify that time; the only requirement is that the timeout for the motor has to
be longer than for the laser.
Laser timeout: (5, 10, 15 minutes)
Motor timeout: (5, 15, 30, 60 minutes)
Printing the configurations (RS-485 model only)
You can have the configurations of the scanner, printed by the printer of the POS
terminal.
1
Turn on the POS terminal and load the initial program (IPL).
Note: For additional information, see Problem Determination Guide for the
operating system.
2
On the keyboard of the POS terminal, press S1, enter 91, and press S2.
The message “T0010 ENTER TEST REQUEST” appears on the POS ter-
minal display.
3
Enter 96, and press S2.
The message “PRINTING CONFIGURATION” appears on the POS terminal
display, and the printer prints the scanner configuration.
4
To leave this mode, enter 99 from the keyboard of the POS terminal, and
press S2.
You can print the scanner configurations by use of either the reference diskette or
service diskette, depending on the type of the terminal used. To find out which
diskette you should use, see the hardware service manual for the terminal, and
follow the procedure for that diskette.
3-4
IBM 4685-L0D Scanner: Setup, Operation, and Service Guide