IBM 450 xSeries, Руководство пользователя

Страница: 36 / 68

Authentication Protocol
The default is CHAP then PAP. Make sure that the value in this field
matches your client settings.
For detailed information about the PPP settings, see the information about
configuring PPP access over a serial port in the
Remote Supervisor Adapter
User’s Guide on the IBM xSeries Documentation CD.
6. Press F6 to apply the changes.
7. Press Esc. After the Warning window opens, press Enter to restart the Remote
Supervisor Adapter.
8. Press Esc to return to the Configuration Settings window.
If you need to configure the serial port, go to “Configuring the serial port for
text-based remote access” on page 21.
9. Press Esc to return to the Utility program main window.
10. Use the arrow keys to select Exit Utility from the menu or press Esc to close
the Utility program.
11. Remove the diskette or CD from the drive. The server restarts automatically.
12. Continue with “Installing Advanced System Management device drivers”.
Installing Advanced System Management device drivers: You must install the
ASM device drivers for the server. The device drivers enable communication
between the Remote Supervisor Adapter and the server in which it is installed. You
can obtain the most current device drivers from the World Wide Web at
http://www.ibm.com/pc/support/.
Notes:
1. If you are installing device drivers manually, note the following requirements:
v You must install the operating system on the server before you install the
ASM device drivers. For information about installing the operating system,
see the documentation that comes with the operating system.
v
Before installing the ASM device drivers for the Remote Supervisor Adapter,
stop any system-management application.
After you install the ASM device drivers, go to “Configuring the remote control
password” to set the remote control password.
Configuring the remote control password: If you want to use the remote control
features of the Remote Supervisor Adapter ASM Web interface, you must configure
the remote control password using the Configuration/Setup Utility program.
To set up a remote control password, complete the following steps:
1. Start the server and watch the monitor screen.
2. From the EFI Boot Manager startup options, select the Configuration/Setup
Utility program.
3. Use the Up Arrow and Down Arrow keys ( ↑ and ↓ ) to select System Security;
then, press Enter. The System Security window opens.
4. Select Remote Control Security Settings ; then, press Enter. The Remote
Control Security Settings window opens.
5. Enter the Remote Control Password that you will use each time you log into
the remote control features of the Remote Supervisor Adapter ASM Web
Interface.
6. Select Save New Remote Control Password ; then, press Enter.
24
xSeries 450: User’s Guide