IBM 4247 Model 003, Руководство пользователя

Страница: 292 / 392

Printer Adjustments
You can make adjustments to your printer to maintain print quality. The
adjustments can be set and then tested by running a print test without having to
exit the menu. There is a set of printer adjustment parameters for each forms path:
Front, Rear, Bin 1, Bin 2, Bin 3, and Manual. Chapter 11, “Printer Adjustments”
describes the procedures for checking and changing the values of the printer
adjustments. The following are the available printer adjustment parameters:
v
Front Automatic Forms Thickness Adjustment (AFTA)
v
Front Tear Position
v
Front Left Margin Alignment
v
Front Paper Load Position
v
Rear Automatic Forms Thickness Adjustment (AFTA)
v
Rear Tear Position
v
Rear Left Margin Alignment
v
Rear Paper Load Position
v
ASF Bin 1 AFTA
v
ASF Bin 1 Left Margin Alignment
v
ASF Bin 1 Paper Load Position
v
ASF Bin 2 AFTA
v
ASF Bin 2 Left Margin Alignment
v
ASF Bin 2 Paper Load Position
v
ASF Bin 3 AFTA
v
ASF Bin 3 Left Margin Alignment
v
ASF Bin 3 Paper Load Position
v
Manual Feed AFTA
v
Manual Feed Left Margin Alignment
v
Manual Feed Paper Load Position
v
Bidirectional Adjustment (Available only in Operator Print Test Menu)
v
Sensor Tune (Available only in Operator Print Test Menu)
v
Quit From Menu (Available only in Operator Print Test Menu)
To check or change printer adjustments:
1. Press Test.
2. Press Scroll
↓
or Scroll
↑
until the printer displays
4247 OPERATOR PRINT TESTS
Printer Adjustments
3. Press Enter.
4. Press Scroll
↑
or Scroll
↓
until the desired value for Printer Adjustments is
displayed.
5. Press Enter and change the values you wish to change.
6. Press Start to run a print test for acceptable quality and alignment.
If the quality is not acceptable, return to Step 3, otherwise, continue.
7. Press Form Feed to see what you printed.
8.
Press Cancel Print to make the printer ready or Return to make the printer not
ready (see “General Test Instructions” on page 273).
282
4247 Model 003 User’s Guide