IBM 4002-C2A, Инструкция по установке и эксплуатации

Страница: 38 / 98

Table 4. Summary of installation tasks (continued)
Task
number
Task Where to find more information
2 Optionally insert a second or
redundant power supply. If you need
to install a power supply, it may be
easier to install it before mounting the
device, although the power supplies
are “hot swappable” and a power
supply can be installed or removed
after the device is mounted and
powered-on.
CAUTION:
Remove the power cord from a power
supply before you install it in or
remove it from the device. Otherwise,
the power supply or the device could
be damaged as a result. (The device
can be running while a power supply
is being installed or removed, but the
power supply itself should not be
connected to a power source.)
“Installing a redundant power supply”
on page 14
4 Install the device in an equipment
rack. “Installing the device” on page 16
5 Once the device is physically installed,
plug the device into a nearby power
source that adheres to the regulatory
requirements outlined in this manual. “Powering on the system” on page 21
6 Verify that the system LEDs are
registering the proper LED state after
power-on of the system. “Verifying proper operation” on page
22
7 Attach a terminal or PC to the device.
This will enable you to configure the
device via the Command Line Interface
(CLI). “Attaching a PC or terminal” on page
23
8 No default password is assigned to the
CLI. For additional access security,
assign a password. “Assigning permanent passwords” on
page 25
9 Before attaching equipment to the
device, you need to configure an
interface IP address to the subnet on
which it will be located. Initial IP
address configuration can be
performed using the CLI with a direct
serial connection. Subsequent IP
address configuration can be
performed using the management
interface. “Configuring IP addresses” on page 26
10 Once you power on the device and
assign IP addresses, the system is
ready to accept network equipment. Chapter 4, “Connecting a c-series
switch to a network device,” on page
25
13 Secure access to the device. Configuration Guide
12
IBM Ethernet Switch c-series Installation and User Guide