IBM 330 Type 6577, Руководство пользователя

Страница: 29 / 102

Setting and Changing a Power-On Password:
Use
the Configuration/Setup Utility program to set or change
a power-on password. You can use any combination of
up to seven characters (A–Z, a–z, and 0–9) for your
power-on password. Keep a record of your password in
a secure place.
To set or change a power-on password:
1. Start the Configuration/Setup Utility program (see
“Using the Configuration/Setup Utility Program” on
page 16).
2. Select System Security from the Configuration/Setup
Utility menu.
3. Select Power-on Password.
4. Type your password and press the down-arrow key.
5. Type your password again.
6. Select Set or Change Power-on Password.
7. At Password Prompt, select On, Off, or Dual.
8. Press Enter.
9. Remember to save the changes when you exit from
the Configuration/Setup Utility program.
Additional Information for PS/2 Mouse Users
The following statement applies to only those who use
a PS/2 mouse; a serial mouse is not affected by the
Unattended Start mode.
The Unattended Start mode prevents the computer
from detecting that a mouse is attached. Therefore,
the mouse device driver will not be loaded
automatically through the CONFIG.SYS or
AUTOEXEC.BAT files when Unattended Start mode is
enabled. You will have to load it later.
If you are using the OS/2 operating system, you must
do one of the following before enabling the
Unattended Start mode:
Ÿ
Remove the mouse driver statement from the
CONFIG.SYS file, or
Ÿ
Set the CONFIG.SYS file so the operating system
does not stop on a device-driver error. For
example, use the PAUSEONERROR=NO
statement.
Chapter 3. Operating Your Personal Computer
19