IBM 2859-A10, Инструкции по установке и настройке, Страница: 12 / 26

8
Any expansion units should be installed. Verify that all expansion unit
IDs are correct and sequential in the individual loop(s). Also verify the
speed switches are set correctly. Refer to the
for the N series expansion unit to which you are
connecting.
If this system was configured by/at manufacturing, there are labels on
the outside of the packaging carton and on the side of the expansion
unit chassis to indicate the order of expansion units and on which
node (1 or 2) expansion units should be located. Make certain the
expansion units are placed and cabled according to these labels.
Installation and Setup
Instructions
Replace the front bezel of the N3300 by snapping it onto the storage
system chassis.
3.5
3.6
From the rear of the rack, attach the rear tie down bracket in the
orientation shown to the rails using four M5 flat head screws. The tie
down bracket should be over the rear of the system unit.
Tie down bracket
M5 flat head screws
3.4
3.3
A t the front of the rack, us four
black screws in the H and H holes secure
the system unit
s shown in the previous illustration, a e
M5x40 (two for each rail) 2 5 to
to the rack. Thread the screws through the system unit
bracket, the spacer plate, and the rack frame rail into the threaded rail
nuts. Tighten the screws using a screwdriver.