IBM 2640-60x, Руководство по техническому обслуживанию аппаратной части

Страница: 45 / 110

Hibernation Mode:
In hibernation mode, the
following occurs:
Ÿ
The system status, RAM, VRAM, and setup data are
stored on the hard disk.
Ÿ
The system is powered off.
Note
The computer cannot enter hibernation mode if it has
been powered on with ac power and a communication
PC Card is used.
The following events cause the computer to enter
hibernation mode:
Ÿ
Hibernation mode is requested by the Fn key
(Fn
+
F12).
Ÿ
Timer conditions are satisfied in suspend mode.
Ÿ
A critically low battery condition occurs.
Ÿ
The PS2 HIBernation command is set in the
ThinkPad Configurations program.
The computer exits hibernation mode and resumes
operation when the power-on switch is pressed. When
power is turned on, the hibernation file in the boot record
on the hard disk drive is read and system status is
restored from the hard disk drive.
Port Replicator Power Overload:
If a power
shutdown occurs intermittently when PC Card devices are
used with a port replicator, suspect an over-current
problem. Some PC Card devices use much power; if the
maximum usage of each device occurs simultaneously, the
total current exceeds the limit, thereby causing a power
shutdown. Isolate this problem by removing one of the
devices, and use the computer under the same condition
to see if a power shutdown occurs. Do this procedure for
all devices to help determine the cause.
ThinkPad 560X (2640-60x, 70x)
35