IBM 2582, Инструкция по установке и эксплуатации

Страница: 69 / 108

Connecting the cables
Attention: To prevent damage to equipment, connect the power cords last.
If the server cables and connector panel have color-coded connections, match the
color of the cable end with the color of the connector. For example, match a blue
cable end with a blue panel connector, a red cable end with a red connector, and
so on.
The following illustration shows the input/output (I/O) connectors on the rear of the
server.
Power connector
Serial 1 (Com1)
USB connectors
Ethernet
connector 1
Video
Ethernet transmit/
receive activity
LED
Ethernet link status
LED
Power switch
Ethernet
connector 2
Ethernet transmit/
receive activity
LED
Ethernet link status
LED
Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or an external device, you might receive a message that the configuration
has changed. The Setup utility starts automatically so that you can save the new
configuration settings. For additional information, see “Using the Setup utility” on
page 54.
Some options have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each option.
If the server has a ServeRAID adapter and you have installed or removed a hard
disk drive, see the ServeRAID documentation for information about reconfiguring
the disk arrays.
Connecting external devices
If you install a supported optional adapter, you can attach external devices to the
server.
To attach an external device, complete the following steps:
Chapter 2. Installing optional devices
51