IBM 2498-B40, Информация о сервисе

Страница: 29 / 78

v One RS-232 serial port with RJ45 connector for initial switch setup (if not using
EZSwitch Setup) and factory default restoration. (The integral LEDs remain unlit
at all times.)
v
A USB port providing connections for storage for firmware updates, output of
the
supportSave command and storage for configuration uploads and
downloads
v Two hot-swappable, redundant power supply and fan FRUs. There are two fans
per FRU
v
Rack-mount design (1U form factor) in a 19-inch EIA rack
v One LED (green/amber) per FC port to indicate status
v One LED (green) for system power
v
One LED (green/amber) for system status
v Two Ethernet LEDs (integrated with RJ45) for speed and activity status
v
SEEPROM for switch identification
v Voltage monitoring
v
Fan monitoring
v Temperature monitoring
v
Real-time clock (RTC) with battery
v The EZSwitchSetup wizard, which makes SAN configuration a three-step
point-and-click task
Port side of the switch
The port side (see Figure 1) includes the system status LED, console port, Ethernet
port and LEDs, USB port, and Fibre Channel ports and the corresponding port
status LEDs.
1
System status LED
6
FC ports 44-47
2
Management Ethernet
port with LEDs
7
FC ports 4-7
3
USB port
8
Switch ID pull-out tab
4
FC ports 0-3 (all LEDs
above)
9
Serial console port
5
FC ports 40-43
10
System power LED
Note: The two LEDs on the serial console port are nonfunctional.
4 2 3 1
9 8 7 10
5
6
b48f006
Figure 1. Port side view
Chapter 1. Introducing the SAN48B-5
3